April 17, 2018 at 6:18PM

0

3d lut in Davinci Resolve

Can you adjust the amount of a lut in Resolve the same way you can in Premiere? I'm trying to learn Resolve but can't seem to figure how to dial in the amount of an applied 3d lut. I know you can control a lot of other parameters just wondering if there is an easy way to do this. Thanks in advance!

4 Comments

Found a method, in case anyone else is curious... https://lutify.me/support/documentation/how-can-i-change-the-strengthopa...

April 17, 2018 at 6:25PM

0
Reply
avatar
Stephen Herron
Writer/Director
1619

They way I do it is after adding your LUT to a node just adjust the key output. Anything less than one will reduce it's strength.

April 18, 2018 at 12:11PM, Edited April 18, 12:11PM

8
Reply

there is many way to do that, you can change the opacity of node, you can stack a layer node that allow you to blend in different way the lut effect, you can do a qualifier to apply a lut only in a part of picture, and so on... Resolve had tons of tools and solution to do everything you can think about color, and more :-D

April 18, 2018 at 4:34PM

0
Reply
avatar
Carlo Macchiavello
Director
700

But yeah, the simplest way I know is to go to the Key panel and adjust the Gain, I believe it is, to something like .9, .8 etc. Basically just changing how strong the node/LUT is.

April 20, 2018 at 4:43AM

0
Reply

Your Comment